Expert Answers about Entegra Coach
- 2021 Entegra Aspire Brake Controller Connection
- Great selection of the Prodigy P3 # 90195 brake controller - definitely one of my favorites due to ease of use!
According to my research your 2021 Entegra Aspire is built on a Spartan chassis. While I imagine there are some wires either up under the dash near the steering column or underneath the driver's seat, there hasn't been any information released about a brake controller plug so you'll likely have to hardwire it in.
If you reach out to Entegra with your VIN they should be able...
view full answer... - Can Axle Perches Be Welded to the Frame?
- Thanks for the picture! That axle perch is usually attached to your trailer's frame with bolts not a weld. I would definitely consult with the dealer you purchased your Carson trailer from. I recommend attaching the Lippert Axle Riser Kit - Single Diamond Torsion Axle item # LC270682 with the included hardware and not welding it to your motorhome.
view full answer... - Do You Need to Have the RF Controller for Blue Ox Patriot 2 & Patriot 3 Supplemental Braking Systems
- While it is recommended to use the RF Controller for Blue Ox Patriot II or Patriot 3 Supplemental Braking Systems # BLU66CR, the systems can be used without it.
The Blue Ox Patriot II and Patriot 3 systems are inertia based braking systems. This means that the systems sense the motion and when it senses that the vehicle is slowing down it applies the brakes.
What you are missing out on if you do not use the RF controller is the manual override, ability to adjust the brake force from the...
view full answer... - Which Side of the Power Cord Does the SmartPlug Connector Plug Assembly for RV Power Cords Install
- The SmartPlug Connector Plug Assembly for RV Power Cords part # SM47FR replaces the connector that installs on the trailer side, into the power inlet. It will also require the SmartPlug RV Power Inlet part # SM57FR or you can purchase both using the SmartPlug RV Power Inlet and Connector part # SM77FR.
view full answer... - How To Remove Strainer on LaSalle Bristol RV Shower Drain 34433R450LES
- To remove the strainer on your LaSalle Bristol RV Shower Drain w/ Strainer # 34433R450LES you will simply need to use a flat head screw driver to turn the strainer counter clock wise and then carefully pry it up. When you are done cleaning the trap you will be able to press it back into place and rotate it clockwise to lock it back in.
I included a video of the # 34433R450LES for you to take a look at.
view full answer... - Is It Normal For The Brake Buddy Stealth Controller's Mode Indicator Light To Remain On
- As long as the in-cab controller of the Brake Buddy Stealth Supplemental Braking System # HM39530 has power the mode indicator light will remain on. The power draw of this light is so low that it would take a considerable amount of time for it to drain the battery.
view full answer... - Adding A Second Battery To Your Go Power Overlander Solar Charging System Battery Bank
- To hook up a second battery to your Go Power Overlander Solar Charging System with Digital Solar Controller - 200 Watt Solar Panel Item # 34282181 you'll need the following:
Some 10 AWG wire to run a positive and negative line from the second battery positive and negative ports on the back of the 30 amp solar controller # 34276119 to the battery.
You'll need a wire stripper/crimper and some ring terminals to hook up to the battery which you can find in the Ratcheting Crimper Set for...
view full answer... - Wiring the Replacement Motor Klauber A-300 Model
- I called Lippert about your question on the Replacement Motor Assembly for Lippert RV Slide-Outs - Klauber A-300 Model, # LC157511. Their Tech Rep stated that the two smaller wires are to power the brake release/engage on the slide and should be connected to the red wire, then remove and replace the motor and wiring with current.
view full answer... - Trailer Braking System Difference When Connected to a Coach with Air Brake System
- This is an excellent question. I reached out to some manufacturers and their tech's didn't know, so I did a little more research to help.
For an air brake motor coach, when you hit the engine brake or jake brake the engine slows the vehicle by opening exhaust valves in your cylinders while at the top of the compression stroke versus using the air brake system to slow the vehicle using the air brake system. The brake lights still need to light in most states because you are decelerating,...
view full answer... - Securing Cables of Wiring Kit RM-152-98146-7 to etrailer Tow Bar e74ZR
- With a wiring kit that has straight cables like your Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Wire to 6-Wire Straight Cord # RM-152-98146-7, all you need to do is wrap the wiring cables right around the arm of your etrailer SD Non-Binding Tow Bar # e74ZR.
This is the common practice for straight cable wiring kits; this will safely allow your cables to be up off the ground so they don't drag or get damaged.
view full answer...
Go To Results